customer drawing title: side entry repair sleeve immersion resistant, 150 deg c, rohs compliant c-wrap unless otherwise specified dimensions are in millimeters.[inches dimensions are shown in brackets] dimensioning and tolerancing per gps (iso standards) raychem devices document no.: d-150-c-1x tolerances: 0.00 0.02 mm 0.0 0.2 mm 0 0.5 mm angles: 030? roughness in micron tyco electronics co rporation reserves the right to amend this drawing at any time. users should evaluate the suitability of the product for their application. rev: a3 date: july 6, 2012 prepared by: ynguyen cage code: 06090 eco number: eco-12-012452 scale: nts size: a sheet: 1 of 1 ? 2012 tyco electronics corporation. all rights reserved. if this document is printed it becomes unc ontrolled. check for the latest revision. adhesive outer sleeve product dimension conductor i.d. (a) cut length (b) awg wire o.d. (note*) part description color code adhesive .05 (.002) sleeve .05 (.002) adhesive 1.5 (.05) sleeve .5 (.02) min max min max D-150-C-11 green 1.11 (.044) 2.29 (.090) 19.75 (. 78) 19.05 (.75) 26 24 0.80 (.031) 1.10 (.043) d-150-c-12 red 1.68 (.066) 2.74 (.108) 20.75 (.78) 19.05 (.75) 22 20 1.10 (.043) 1.50 (.059) d-150-c-13 blue 2.13 (.084) 3.43 (.135) 20.75 (.82) 19.05 (.75) 18 16 1.50 (.059) 2.30 (.090) d-150-c-14 yellow 3.34 (.133) 4.80 (.189) 20.75 (.82) 19.05 (.75) 14 12 2.30 (.090) 2.80 (.110) materials 1. meltable adhesives: environment resistant modified thermoplastic fluoroela stomer. color coded. 2. insulation sleeve: heat-shri nkable, transparent, radiation cross-linke d modified fluoropolymer. color coded. application 1. these parts are designed to provide an environment resistant to repair damaged primary wire that have a radial crack up to 3 60 degrees, nicks/scrapes not longer than ?? on the insulation rated for 135 ? c minimum and no damage to wire conductor. for insulations procedures refer to rpip 1101. 2. install using tyco electronics approved convection or infrare d heating tools in accordance with tyco electronics. when inst alled with approved convection or infrared h eating tools, assemblies will meet the performance requirements of te d-6201 spec. infrared tools are not recommended for use with black cable jackets. 3 temperature range: -65 ? c to +150 ? c. note*: if the o.d. of wire is out of the range that is speci fied in table, use the next size of c-wrap up or down. wire od
|
